Hey thanks for stopping in. This is a new website and 3D printing will be a large part of it. I do have several printers, although I’ve only been at this for a few months. So here’s where I am at with this XY-3 SE Printer.
It currently will auto level fine, it just won’t come down to a proper “Z Offset”. I have a video of this here:
Now I have been on the FB group and done some reading and made one post. This post is to further assist in problems with this printer. Here is one solution that I saw a post about. I will link it here:
Tronxy XY-3 SE “Entire Original SD Card”
*Fixed! Use This Chitu File to “Remesh” prusa Slicer
I used this Chitu File found within the “Cura” Slicer software on the original SD Card that came with the Printer. Download the file here, and run it on your Tronxy XY3-SE. Thanks for visiting and happy printing!
Below is a short video of tronxy (aka “Laser Tron”) up & running again. Working hard on multi extrusion printing here at the haven
~HoodBilly~
