Tronxy XY-3 SE Problems: Crashes Into Heatbed After Leveling (When Starting Print) Help!

Hey thanks for stopping in. This is a new website and 3D printing will be a large part of it. I do have several printers, although I’ve only been at this for a few months. So here’s where I am at with this XY-3 SE Printer.

It currently will auto level fine, it just won’t come down to a proper “Z Offset”. I have a video of this here:

Now I have been on the FB group and done some reading and made one post. This post is to further assist in problems with this printer. Here is one solution that I saw a post about. I will link it here:

Tronxy XY-3 SE “Entire Original SD Card”

hoodbillyhaven.com
hoodbillyhaven.com
Articles: 8

2 Comments

    • Thanks for stopping by I plan to keep this going, but now I have not figured this out. I think it could be bricked. I will be adding much more 3D printing stuff here. Please keep coming around. Thanks ~HoodBilly~

Leave a Reply

Your email address will not be published. Required fields are marked *